Digi-star CC400 Bedienungsanleitung PDF herunterladen (Seite 9)

Operators Manual

D3674-GB Rev C

Running Self Test

To run the self-test on the Cab Control 400, follow instructions under “Setup Cab Control

400” steps 1 through 7 on page 4 and press [Net/Grs] in step 8.

Low Battery Indication

If the power supply voltage drops below the (10.5 Volts), the message RECHARGE BATTERY -

TURNING OFF” and L0 PWR will periodically show on the display to alert the operator of the low

battery condition.

NOTE: If

LO BAT

is displayed, the indicator power (not the Cab Control 400 power) is below

10.5 volts.

Warning! Disconnect the Cab Control 400 power cord before jump-

starting or fast-charging the battery.

FCC Notifications

FCCID: OUR-24XTREAM

This device complies with part 15 of the FCC rules. Operation Is subject to the following

conditions:

(1) This device may not cause harmful interference and (2) this device must accept any

interference received, including interference that may cause undesirable operation.

To comply with FCC regulations, this device may be used only with approved antennas.

Contact Digi-Star Customer Support for additional information.

Warning! This equipment is approved only for mobile and base station

transmitting devices, separation distances of 20 centimeters (8

inches) or more should be maintained between the antenna and

nearby persons during operation. To ensure compliance, operation

at distances closer than this is not recommended.

1 2 3 4 5 6 7 8 9

Keine Kommentare

Digi-star CC400 Bedienungsanleitung Seite 9